How to Mount a Tongue and Groove Ceiling – A Stylish Upgrade to Drywall A tongue and groove (T&G) ceiling is a wonderful means to add all-natural timber components to your residence. It’s likewise a low-cost and easy way to panel a space. You can discover a selection of various designs as well as sorts of tongue as well as groove boards in your home facilities, lumberyards, and also online. The kind of timber you choose will certainly be essential to the general feel and look of your ceiling. Hemlock is a popular option for tongue and groove ceilings due to the fact that it’s lightweight, easy to deal with, as well as takes paint or tarnish well. Nonetheless, various other types of wood likewise function well for this project. Fir is another good option since it’s inexpensive, light-weight, and also very easy to deal with. You can repaint or tarnish it to match the color scheme of your house, too. If you’re setting up a tongue as well as groove ceiling over drywall, take into consideration using battens rather than nails. This will certainly help level the surface as well as make it more solid for nailing. You can run battens parallel or perpendicular to the framing. Begin by nailing the initial row of slabs, beginning in one corner as well as working down the length of the area. Setting the initial board with the groove side dealing with the wall as well as the tongue facing out. Use two-inch brad nails to fasten directly to the framing or battens; a nail gun speeds up setup. After that, established the next row of boards in place. Repeat the process with each row, readjusting the boards’ positioning as required to guarantee they’re parallel to the previous rows. When the whole ceiling is nailed together, you can set up trims to cover up any kind of subjected sides. These can consist of crown molding, coffered or textured ceiling panels, and also also timber strips leaving the edge of the ceiling. To make certain the trims fit flush against the boards, it’s important to see to it that each end of the ceiling is in proportion. If you’re uncertain, lay the planks out on the floor and mark the edges to make sure they are identical. When you’re completed with the very first row of slabs, glide the grooved side of the next board over the tongue of the very first board as well as safeguard it in place by driving a nail through both sides. This is similar to a dado joint, but the tongue of the following board is a little deeper than the tongue of the previous board, leaving the area for a slight amount of growth or tightening in reaction to changes in temperature or moisture. Continue this process for every two-three rows, examining that each row is still parallel to the previous row or the wall surface. If the joists or rafters are not level, you might require to rip several of the boards. If you don’t have a saw or a table saw, it’s feasible to employ a carpenter or general service provider to reduce the tongue and groove joints for you. It can be a bit a lot more costly than installing the ceiling by yourself, but it deserves it in the future for a smooth as well as expert appearance.